Altium Designer Documentation


Created: June 12, 2016 | Updated: April 11, 2017

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to abort the current simulation analysis and waveform generation, in the SimData Editor's Waveform Analysis window.


This command is accessed from the SimData Editor by clicking the  button on the SimView Standard toolbar.


After launching the command, the simulation will be stopped. The waveforms for any collected data will be displayed to the extent that they are already generated, up to the point of the abort. In some cases, waveforms will be partially displayed, in other cases, no data will be present.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: