Altium Designer Documentation

CreateFFTChart

Created: March 10, 2022 | Updated: March 10, 2022

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to perform a Fast Fourier Transform on the active chart and display the results in a new chart.

Access

This command is accessed from the SimData Editor by choosing the Chart » Create FFT Chart command from the main menus.

The command is only available provided the active chart is plot-based rather than text-based (i.e. Operating Point or Transfer Function analysis).

Use

First, ensure that the chart on which you want to perform a Fast Fourier Transform is selected in the Waveform Analysis window. This is achieved by clicking on the required analysis tab at the bottom of the window.

After launching the command, the FFT will be performed and the results displayed in a new chart, a new tab will be added (<AnalysisType>_FFT) and made the active chart in the window.

Tip

The new chart will be added after the last chart in the document.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: