Altium Designer Documentation

Delete

Created: March 10, 2022 | Updated: March 10, 2022

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to delete the selected waveform from the active wave plot in the Waveform Analysis window.

Access

This command is accessed from the SimData Editor by choosing the Edit » Delete command from the main menus.

Use

First, ensure that the waveform that you want to delete is selected. This is achieved by clicking on the waveform name (a selected waveform will become bolder in color and have a dot to the left of its name). After launching the command, the waveform will be deleted.

Notes

  • If the command is used without having selected a waveform, the entire active wave plot will be deleted.
  • When a waveform is selected, filtering is applied using the name of the waveform as the scope. All other waveforms in the active chart with different names will be masked (becoming dim). The extent of the maskin9 (how dim the non-selected waveforms become) can be controlled through the use of the Mask Level slider bar accessed by clicking the Mask Level button located at the bottom-right of the Waveform Analysis window. If more than one waveform of the same name exists in the active chart, the non-selected instances will remain fully visible.
  • If you want to remove all waveforms from the active wave plot and leave the empty plot intact, use the Clear command.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: