Altium Designer Documentation

Redo

Created: July 7, 2017 | Updated: September 18, 2017

Parent page: SystemDesigner Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This feature is used to restore changes made by the Undo feature, in the active Multi-board Schematic document (*.MbsDoc). Multiple levels of redo are supported.

For a high-level look at multi-board design within Altium Designer, see Designing Systems with Multiple Boards.

Access

This command can be accessed from the Multi-board Schematic Editor by:

  • Choosing the Edit » Redo command from the main menus.
  • Clicking the  button on the Quick Access Bar.
  • Using the Ctrl+Y keyboard shortcut.
The command only becomes available provided the Undo command has been used.

Use

After launching the command, the last command to be undone by the Undo operation will be 'redone', and the document will be returned to its state prior to the last Undo taking place. Use the command repeatedly to redo previously undone operations.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: