Altium NEXUS Documentation

ToggleMeasurementUnits

Created: July 24, 2017 | Updated: July 24, 2017
現在、バージョン 2.1 をご覧頂いています。 最新情報については、バージョン 4 の をご覧ください。

Parent page: PcbDrawing Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to toggle between the use of Imperial and Metric measurement units, for the active Draftsman document (*.PCBDwf).

For a high-level look at how the Altium Draftsman Drawing System provides an interactive approach to the creation of production documentation for your PCBs, see Draftsman.

Access

This command can be accessed from the PcbDrawing Editor by:

  • Choosing the View » Toggle Units command, from the main menus.
  • Using the Q keyboard shortcut.

Use

After launching the command, the units of measurement in force for the active Draftsman document will be toggled. If they were previously Imperial units (mil), they will toggle to Metric (mm), and vice-versa.

Tips

  1. This command effectively toggles the setting for the Units field, in the Units section of the Properties panel.
  2. You can quickly verify the active units from the Status Bar, by looking at the entry for the coordinates, at the left-hand end of the bar.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: