Altium NEXUS Documentation

ToggleElectricalGrid

Created: June 21, 2017 | Updated: June 21, 2017
現在、バージョン 2.1 をご覧頂いています。 最新情報については、バージョン 4 の をご覧ください。

Parent page: Schematic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to turn the cursor electrical grid on or off.

Access

This command can be accessed from the Schematic Editor by:

  • Choosing the View » Grids » Toggle Electrical Grid command, from the main menus.
  • Choosing the Toggle Electrical Grid command, on the Grids drop-down () of the Utilities toolbar.
  • Using the Shift+E keyboard shortcut.

Use

The electrical grid is a special grid designed to assist you in wiring up your schematic. The electrical grid defines a range around electrical objects within which the cursor is "captured" by the object, overriding the current snap grid.

Wires, part pins, etc, are all affected by the electrical grid. With the electrical grid turned on, as you wire up your schematic, the cursor will automatically "find" electrical hot spots, making it easier to connect to electrical objects.

Launch the command to toggle the electrical grid status on or off.

Tips

  1. The electrical grid for the currently active schematic sheet can also be enabled/disabled when configuring Document Options through the Properties panel (when no objects are selected in the workspace). Simply enable/disable the Snap option (in the General section of the panel).

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: