Altium NEXUS Documentation

Bending Line

Created: 21.02.2019 | Updated: 21.02.2019


The Bending Line dialog

Summary

The Bending Line dialog allows you to edit the properties of a bending line. If a region has a layer stack assigned and that stack has the Flex option enabled, then Bending Lines can be placed across that region. Each Bending Line has a radius, bend angle, and an affected area width property, allowing them to be displayed in their folded state as they would be in a real-world situation.

Access

The dialog can be accessed in the following ways:

  • Ensure you are in Board Planning Mode (View » Board Planning Mode). Click Design » Define Bending Line. Place the resulting crosshair in the desired location then press the Tab key.
  • Right-click on a placed Bending Line then select Properties from the context menu.

Options/Controls

  • Bending Angle - the angle that the surface of the flex region is to bend.
  • Radius - the distance away from the bend surface that the bending center-point is located.
  • Affected area width - the width of surface area that will be bent for the given Radius and Bending Angle.

When one of the first three properties are edited/changed, the other two properties are calculated and updated automatically. Note that each Bending Line's Affected area width is displayed on the board in dark yellow.

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: