Redo | Altium Designer 20.1 Technical Documentation

Redo

Using Altium Documentation

Created: September 18, 2017 | Updated: October 13, 2017

Now reading version 20.1. For the latest, read: Redo for version 21

Applies to Altium Designer versions: 18.0, 18.1, 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: MultiBoardAssembly Commands

The following pre-packaged resource, derived from this base command, is available:

Redo

Applied Parameters: None

Summary

This feature is used to restore changes made by the Undo feature, in the active Multi-board Assembly document (*.MbaDoc). Multiple levels of redo are supported.

For a high-level look at multi-board design within Altium Designer, see Designing Systems with Multiple Boards.

Access

This command can be accessed from the Multi-board Assembly Editor by:

Choosing the Edit » Redo command from the main menus.
Clicking the button on the Quick Access Bar, or MBA Toolbar toolbar.
Using the Ctrl+Y or Ctrl+Backspace keyboard shortcuts.

The command only becomes available provided the Undo command has been used.

Use

After launching the command, the last command to be undone by the Undo operation will be 'redone', and the document will be returned to its state prior to the last Undo taking place. Use the command repeatedly to redo previously undone operations.

Printer-friendly version

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Summary

Access

Use

Contact Us