Altium Designer Documentation

PlaceComponentsFromFile

Created: June 19, 2017 | Updated: December 18, 2020

Parent page: PCB Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to position components within your design based on locations specified within a pick-and-place file. This feature is particularly useful if you are given critical placement information from the Mechanical Designer in the form of a .pik file. It can also provide a useful method for quickly applying a favorite/preferred placement obtained by previously generating a Pick and Place file from Altium Designer.

A .pik file can be generated from Altium Designer by generating a standard pick and place file - in normal .txt format - then changing the extension to .pik. Note that only a pick and place file generated in .txt format can be used in this way. Use of a pick and place file that is generated in .csv format is not supported.

The .pik files that Altium Designer generates do not need any modification.

Access

This command is accessed from the PCB Editor by choosing the Tools » Component Placement » Place From File command from the main menus.

Use

First, ensure that any components that are not to be moved are locked by setting their Locked option. This can be performed through the Properties panel or through the PCB List panel - both panels allow you to quickly set this option for all required and selected components in a single action.

After launching the command, the Load File Name dialog will open. Use this dialog to browse to and open the relevant .pik file for the design. Any components in the design that are listed in the .pik file will have their positions updated if their current position is different from that listed in the file (the file position will be used).

Tips

  1. A component must already exist in the workspace and have the corresponding designator as listed in the .pik file, in order for the move to take place.
  2. The Mid X and Mid Y coordinates in the pick-and-place file are used as the reference for position changes; other coordinates are ignored.
  3. Different components in the .pik file can use different units (mm or mil) if required.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: