Applied Parameters: None
This command is used to change the view in the main design window, such that the active Draftsman document (*.PCBDwf) is made completely visible (where possible).
This command can be accessed from the PcbDrawing Editor by:
- Choosing the View » Fit Document command, from the main menus.
- Using the Ctrl+PgDn keyboard shortcut.
After launching the command, the view in the main design window will change in order to fit the entire document, where possible. This of course will depend on the current sizing of the main design workspace within Altium Designer. For a single sheet Draftsman document, this should be no problem, but if the document contains multiple sheets, fitting the entire document into view, especially if there are a great many sheets, may not be possible. In this case, the software will attempt to fit what it can, with the center of the document at the center of the main design window.