The following pre-packaged resources, derived from this base command, are available:
Toggle all Sheet Entry IO Type in Selected Sheet SymbolsExpandCollapse
Applied Parameters: ObjectKind=SheetSymbol
Summary
This command is used to toggle the I/O Type for all sheet entries in one or more selected sheet symbols, simultaneously, and where applicable.
Access
This command can be accessed in the Schematic Editor, by:
- Choosing the Edit » Move » Toggle All Sheet Entries IO Type In Selected Sheet Symbols command from the main menus.
- Locating and using the Toggle All Sheet Entries IO Type In Selected Sheet Symbols command on the Active Bar.
If the command has been recently used from the Active Bar, it will become the active/visible button. Where other commands are available, this is indicated by a triangle at the bottom-right corner of the button. Click and hold on the active button to access a menu of all associated commands for that grouping.
The command will only be available provided at least one sheet symbol is currently selected on the active schematic sheet.
Use
After launching the command, the I/O Type defined for each sheet entry will be toggled, where applicable. The actual change depends on the current I/O Type as follows:
- Unspecified remains Unspecified.
- Output changes to Input.
- Input changes to Output.
- Bidirectional remains Bidirectional.
Tips
- This command acts only on standard sheet symbols, and not device sheet symbols, or managed sheet instance symbols.
