Altium Designer Documentation

DeleteToEndOfLine

Using Altium Documentation
Created: February 1, 2023 | Updated: February 1, 2023
This document is no longer available beyond version 21. Information can now be found here: Text Deletion Shortcuts for version 23
Applies to Altium Designer version: 21

Parent page: TextEdit Commands

The following pre-packaged resource, derived from this base command, is available:

Delete to End of Line


Applied Parameters: None

Summary

This command is used to delete all characters from the current cursor position to the end of the current line.

Access

Access to this command is made using the Ctrl+Q+Y keyboard shortcut only.

Use

Simply position the text cursor at the required position in the line and launch the command. All characters from the cursor to the end of the current line will be deleted. The cursor will effectively remain at its original location.

Tips

  1. The deleted characters can be restored using the Undo command.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

Contact Us Now
We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: