Altium NEXUS Documentation

SetComponentReference

Created: 27.07.2015 | Updated: 17.07.2018

Parent page: PCB Commands

The following pre-packaged resources, derived from this base command, are available:


Applied Parameters: Location=Pin1

Summary

This command is used to set the component reference point to be pin 1 of the component footprint.

Access

This command is accessed from the PCB Library Editor by choosing the Edit » Set Reference » Pin 1 command from the main menus.

Use

First, ensure that the component that you wish to set the reference for is selected in the Components list in the PCB Library panel (and is therefore the active component in the main design window).

After launching the command, the reference point will be set to pin 1 of the footprint and this point will be set to 0,0 - it becomes the new relative origin and all primitives will have their locations updated relative to this point.

Tips

  1. This reference point is actually the relative origin for the workspace and is the point by which the component footprint is picked up by the cursor in Place and Move operations.


Applied Parameters: Location=Center

Summary

This command is used to set the component reference point to be the center of the component footprint.

Access

This command is accessed from the PCB Library Editor by choosing the Edit » Set Reference » Center command from the main menus.

Use

First, ensure that the component that you wish to set the reference for is selected in the Components list in the PCB Library panel (and is therefore the active component in the main design window).

After launching the command, the reference point will be set to the center of the footprint and this point will be set to 0,0 - it becomes the new relative origin and all primitives will have their locations updated relative to this point.

Tips

  1. This reference point is actually the relative origin for the workspace and is the point by which the component footprint is picked-up by the cursor in Place and Move operations.


Applied Parameters: None

Summary

This command is used to set the component reference point to a user-defined location.

Access

This command is accessed from the PCB Library Editor by choosing the Edit » Set Reference » Location command from the main menus.

Use

First, ensure that the component that you wish to set the reference for is selected in the Components list in the PCB Library panel (and is therefore the active component in the main design window).

After launching the command, the cursor will change to a cross-hair and you will be prompted to select a new relative origin. Position the cursor at the point you wish to make the reference then click or press Enter. This point will be set to 0,0 - it becomes the new relative origin and all primitives will have their locations updated relative to this point.

Tips

  1. This reference point is actually the relative origin for the workspace and is the point by which the component footprint is picked-up by the cursor in Place and Move operations.

 

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: