Applied Parameters: Server=PinSwapper|Command=RunTASKINGPinSwapper|StartServer=True
This command is used to interactively perform pin-swapping within the Altium NEXUS PCB design workspace, and dynamically synchronize changes with your TASKING Pin Mapper tool. A component pin is swappable with another pin in that component when both pins have the same Pin Group. The swapping feature supports more than just pins; it also supports swapping a partially routed net. This is ideal if you are working on a dense board and escape routing from the components at both ends of a connection. When you perform a pin swap, any connected routing is also swapped to the target net.
This command is accessed from the PCB Editor by choosing the Tools » Pin/Part Swapping » Interactive TASKING Pin/Net Swapping command from the main menus.
After launching the command, everything in the PCB workspace is masked (faded) except those pins that are swappable. Keep an eye on the Status Bar. It will prompt you for the next action: Choose Sub-Net to move. After clicking on a swappable pin, you will be prompted to choose a target net for the sub-net to swap. All possible target pins that can be swapped will be highlighted. Click on the target pin to complete the swap action. You will then be ready to perform another pin swap, if required.
As you make pin swaps within the PCB document, those changes are passed dynamically to your TASKING Pin Mapper tool, courtesy of the bi-directional communication support provided through the TASKING Pin Mapper Provider software extension. This ensures that your TASKING embedded source code is kept in-sync without the need to export and import change files.
- The pin group is an attribute of each pin in the component and its value can be any alphanumeric string. The pin groups for the entire component are set up in the Configure Pin Swapping dialog.
- Pin swap information will also appear in the Messages panel.
- Design changes that are a result of performing a pin swap in the PCB editor are propagated back to the schematic using the standard Design Update process (run the Design » Update Schematics command from the PCB Editor).