Altium Designer Documentation

FitSelected

Created: July 7, 2017 | Updated: September 18, 2017

Parent page: SystemDesigner Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to change the view in the main design window, such that all selected objects in the active Multi-board Schematic document (*.MbsDoc) are visible.

For a high-level look at multi-board design within Altium Designer, see Designing Systems with Multiple Boards.

Access

With at least one object selected, this command is accessed from the Multi-board Schematic Editor by choosing the View » Fit Selected Objects command, from the main menus.

Use

First, ensure that all objects that you wish to fit within the displayed workspace are selected.

After launching the command, the view in the main design window will change to fit all selected objects. Depending on the number of objects selected and their respective locations, the selection will be zoomed (in or out) and centered in the window (where possible).

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: