Altium NEXUS Documentation


Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to bring the design closer to you, relative to the cursor position, in the current document.


This command can be accessed from the CAMtastic Editor by:

  • Choosing the View » Zoom In command from the main menus.
  • Clicking the  button, on the CAMtastic Standard toolbar.
  • Using the PgUp keyboard shortcut.
  • Right-clicking within the workspace and choosing the Zoom In command from the context menu.


Launch the command to zoom in on a particular section of the document. Use the command repeatedly to zoom in to a greater extent.


  1. As this command is relative to the cursor position, it is a good idea to position the cursor in the desired location, prior to launching the command, and to use the keyboard shortcut.
  2. This command can be used, through its respective keyboard shortcut, even while another process is running, for example during placement mode.
  3. You can also zoom in by pressing Ctrl whilst rolling the mouse wheel upwards.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: