Altium NEXUS Documentation

PCB_Dlg-InputCoordDialog_CoordEditSnap Grid(1..1000) _AD

Created: July 7, 2022 | Updated: July 7, 2022
このドキュメント ページは、廃止された Altium NEXUS/NEXUS Client (展開された NEXUS ソリューションの一部) を参照しています。PCB 設計、データ管理、共同作業の全ての要求は、Altium Designer (Altium Designer Enterprise サブスクリプション を含む) と、接続された Altium 365 Workspace で利用できます。詳細については、FAQs のページ をご覧ください。

The Snap Grid (1..1000) dialog
The Snap Grid (1..1000) dialog

Summary

The Snap Grid dialog allows you to quickly set a different interval size for the Snap Grid. The Snap Grid pulls the cursor to the nearest point on its defined grid. Depending on how the dialog is accessed, the required value can be applied to both Step X and Step Y, or only Step X, or only Step Y.

For more information about the PCB Grids System, click here.

Access

The dialog can be accessed from both the PCB Editor and PCB Library Editor in the following ways:

  • Click View » Grids » Set Global Snap Grid from the main menus.
  • Use the Shift+Ctrl+G keyboard shortcut.

Options/Controls

Enter the grid interval as required.

The entered grid size is reflected at the left-hand side of the status bar. If the grid was set globally (for both Step X and Step Y), then a single entry for the grid value will be displayed. If the grid was set for Step X or Step Y individually, the individual grid steps will be displayed. The current step sizes for the Snap Grid can also be verified in the Cartesian Grid Editor dialog.
If entering a snap grid setting without specifying units, the entry will be in the default measurement units selected for the design as determined by the Units setting in the Other region in the Board mode of the Properties panel. Specifying units when entering the value (mm or mil) in this dialog will change the default measurement units for the document if not currently the default.
Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: