Altium NEXUS Documentation

Redo

Created: August 8, 2017 | Updated: October 11, 2018

Parent page: UnifiedComponent Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This feature is used to restore changes made by the Undo feature, in the current document. Multiple levels of Redo are supported.

Access

This command can be accessed from the Component Library Editor, when configured in Batch Editor mode, by:

  • Clicking the  button on the Component Library Standard toolbar.
  • Using the Ctrl+Y keyboard shortcut.
The command only becomes available provided the Undo command has been used.
If the Component Library Editor is currently in Single Component Editor mode, switch to the Batch Editor mode using the Tools » Switch to Batch Editor command.

Use

After launching the command, the last command to be undone by the Undo operation will be 'redone', and the document will be returned to its state prior to the last Undo taking place.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: