Altium NEXUS Documentation

SetupPreferences

Created: September 23, 2017 | Updated: September 23, 2017
現在、バージョン 2.1 をご覧頂いています。 最新情報については、バージョン 4 の をご覧ください。

Parent page: WorkspaceManager Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: ObjectKind=OutputPreferences

Summary

This command is used to configure the properties of the currently selected output container, or print job, in the active Output Job Configuration file.

Access

With the required output container/print job selected, this command can be accessed from the OutputJob Editor by:

  • Choosing the Tools » Container Setup command, from the main menus.
  • Using the Ctrl+Shift+O keyboard shortcut.

Use

First, ensure that the output container/print job that you wish to configure is selected, in the Output Containers region, or Hard Copy region of the main job configuration window, respectively.

After launching the command, the applicable settings dialog will appear. Use the dialog to manage and configure the properties of the selected output container/print job, which will be applied when generating output from its linked output generators.

Tips

  1. The associated settings dialog can also be accessed by clicking on the Change link, at the top-right of the container/print job's entry in the Output Containers/Hard Copy region.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: