Created: July 7, 2022 | Updated: July 7, 2022
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: ConstraintsManager Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: Action=Toggle|SetFocus=True


This command allows you to quickly toggle the display of the Advanced constraints options mode of the Properties panel.


This command can be accessed from the Constraints Editor by using the F11 keyboard shortcut.

Note that you must Switch to Document View in the PCB Rules and Constraints Editor to access the Constraints Editor


After launching the command, the Advanced constraints options mode of the Properties panel will either open or close.


  1. If the panel is part of a group of panels, using this command will make it the active panel in the group - bringing it to the front in docked or floating modes, and popping it out in pop-out mode.
  2. Using this command will toggle the display of the panel in the position and mode in which it was last placed.
  3. A currently visible panel will have a check next to its menu entry.
  4. The panel can also be toggled with respect to its visibility, using the View » Panels » Properties command, or by clicking the Panels button (available on the right of the Status Bar) then choosing Properties


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: