Altium NEXUS Documentation

GeneratePatterns

Created: July 26, 2021 | Updated: July 26, 2021

Parent page: PatternsGen Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to open the Dielectric Shapes Generator dialog to automatically create dielectric shapes.

Click here for more information about dielectric shapes in Printed Electronics.

Access

This command is accessed from the PCB editor by choosing Tools » Printed Electronics » Generate Dielectric Patterns from the main menus.

The Printed Electronics Crossover Generator extension must be installed in order to access this command. The extension icon can be found on the Purchased tab of the Extensions & Updates page, which is located by clicking the  drop-down then choosing Extensions and Updates.

Hover over the icon then click  to download the extension. Altium NEXUS must be restarted to complete the installation.

Use

After launching the command, the Dielectric Shapes Generator dialog opens. Use the dialog to create the dielectric shapes needed for Printed Electronics.

Tip

  • When the Dielectric Shapes Generator is run, it will remove all shapes on the target layer(s), then recreate them. If shapes have been defined manually, lock them before running the Dielectric Shapes Generator.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: