Altium NEXUS Documentation

ConvertToKeepout

Created: June 12, 2017 | Updated: July 13, 2018

Parent page: PCB Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None

Summary

This command is used to convert existing primitive objects on signal layers to Keepouts on the same layer. A Keepout in PCB design is a user-defined area or perimeter placed in the layout that copper objects cannot intersect. Typically included to control the area used by automated copper placement actions, such as polygon pours and interactive routing, a Keepout also represents an invalid location when manually placing copper objects. Placed Keepout objects can be configured to specify which type objects they apply to, such as Tracks, Copper areas, Vias and Pads, which significantly enhances the flexibility and effectiveness of Keepouts.

For more information on Keepouts, see Object Specific Keepouts.

Access

This command is accessed from the PCB Editor by choosing the Tools » Convert » Convert Selected Primitives to Keepouts command from the main menus.

Use

First, ensure that the primitives that you wish to convert are selected within the design workspace.

After launching the command, the selected primitives will be converted to keepouts.

Tips

  1. Edit a converted object’s Keepout Layer and applied object Restrictions, as required, through the Properties panel (when the object is selected).
  2. Keepout objects can be converted (back) to their equivalent non-Keepout primitive objects using the Tools » Convert » Convert Selected Keepouts to Primitives command.
Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: