Altium NEXUS Documentation

SnapChange

Created: 11.06.2016 | Updated: 11.04.2017
Вы просматриваете версию 3.2. Для самой новой информации, перейдите на страницу для версии 5

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to toggle between the Off snap mode and the previously selected snap mode (other than Off).

Access

This command can be accessed from the CAMtastic Editor by:

  • Right-clicking within the main workspace and choosing the Snap Change command from the context menu.
  • Right-clicking, while placing a polyline object, and choosing Snap Change from the context menu.
  • Using the Shift+S keyboard shortcut.

Use

After launching the command, the snap mode will either become Off, or the previously selected mode, depending on the current state.

Tips

  1. The current snap mode can be viewed/changed on the CAMtastic panel, and also on the CAM Editor - Drawing Modes page of the Preferences dialog.

 

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: