Redo | Altium Designer 20.1 Technical Documentation

Redo

Using Altium Documentation

Created: December 5, 2018 | Updated: December 17, 2018

Now reading version 20.1. For the latest, read: Redo for version 21

Applies to Altium Designer versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:

Redo

Applied Parameters: None

Summary

This feature is used to restore changes made with the Undo feature in the active Layer Stack to its state previous to the last operation. Multiple levels of redo are supported.

Access

This command can be accessed from the Layer Stack by:

Choosing the Edit » Redo command from the main menus.
Clicking the button on the Quick Access bar.
Using the Ctrl+Z keyboard shortcut.

The command only becomes available provided the Undo command has been used.

Use

After launching the command, the last command to be undone by the Undo operation will be 'redone' and the Layer Stack will be returned to its state prior to the last Undo taking place. Use the command repeatedly to redo previously undone operations.

Printer-friendly version

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Summary

Access

Contact Us