Altium Designer Documentation

SwitchMeasurement

Using Altium Documentation
Created: December 5, 2018 | Updated: December 17, 2018
Now reading version 20.1. For the latest, read: SwitchMeasurement for version 21
Applies to Altium Designer versions: 19.0, 19.1, 20.0, 20.1 and 20.2

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:

Switch Measurement Units


Applied Parameters: Index=n (where n is in the range 0-9)

Summary

This command is used to change the measurement units in the active Layer Stack.

Access

This command can be accessed from the Layer Stack by choosing Tools » Measurement Units then selecting the desired unit of measure. Choose from mil, in, µ, and mm. 

Use


After the command is launched, the measurement units in the Layer Stack change to the unit that was selected.

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

Contact Us Now
We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: