Altium Designer Documentation


Created: October 14, 2022 | Updated: October 14, 2022
Applies to Altium Designer version: 21

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: Index=n (where n is in the range 0-9)


This command is used to change the measurement units in the active Layer Stack.


This command can be accessed from the Layer Stack by choosing Tools » Measurement Units then selecting the desired unit of measure. Choose from mil, inµ, and mm


After the command is launched, the measurement units in the Layer Stack change to the unit that was selected.

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: