Altium Designer Documentation

ToggleMeasurement

Created: December 5, 2018 | Updated: December 17, 2018

Parent page: LayerStackManager Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to cycle through the measurement units in the active Layer Stack.

Access

This command can be accessed from the Layer Stack by using the Ctrl+Q keyboard shortcut.

Use


After the command is launched, the measurement units cycle between mm, in, mil, and µ. Repeatedly launch the command to select the desired units.

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: