Altium Designer Documentation

Stack is not symmetric

Created: January 3, 2019 | Updated: January 3, 2019

The Stack is not symmetric dialog

Summary

The Stack is not symmetric dialog allows you to achieve symmetry in the layer stack.

Access

The dialog is accessed by enabling the Stack Symmetry option in the Properties panel in Layer Stack Manager mode. 

Options/Controls

  • Layer stack symmetry mismatches - the grid displays all detected conflicts in layer stack symmetry.
  • Mirror top half down - the settings of each of the layers above the central dielectric layer are copied down to the symmetrical partner-layer.
  • Mirror bottom half up - the settings of each of the layers below the central dielectric layer are copied up to the symmetrical partner-layer.
  • Mirror whole stack down - an additional dielectric layer is inserted after the last copper layer, then all of the signal and dielectric layers are replicated and mirrored below this new dielectric layer.
  • Mirror whole stack up - an additional dielectric layer is inserted before the first copper layer, then all of the signal and dielectric layers are replicated and mirrored above this new dielectric layer.
Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: