Applied Parameters: None
This command allows you to conveniently jump to a specific component on a schematic source document, targeted by its logical or physical designator.
This command is accessed from the Schematic Editor by choosing the Edit » Jump » Jump Component command from the main menus.
After launching the command, the Component Designator dialog will appear. Enter the component designator for the component you wish to jump to. If the designator is valid and the component exists on a schematic source document within the active project, then the relevant schematic document will be made the active document, and the target component will be zoomed and centered (where possible) within the main design window.
- The project must be compiled before physical designators can be used as the target for a jump.
- For a multi-part component, the first part will be highlighted, with the Find Text - Jump dialog opened. Use this dialog to jump between sub-parts of the component.
- The found component (or all parts for a multi-part component) is also listed in the Messages panel. Double-click a message entry to jump to that component (or part thereof) in the workspace.