Parent page: Schematic Commands
The following pre-packaged resource, derived from this base command, is available:
Applied Parameters: None
This command is used to place an Ellipse object onto the active document. An ellipse is a non-electrical drawing primitive that can be placed on a schematic sheet. It can be filled or unfilled.
Ellipses are available for placement in both Schematic and Schematic Library Editors:
After launching the command, the cursor will change to a cross-hair and you will enter ellipse placement mode. Placement is made by performing the following sequence of actions:
Additional actions that can be performed during placement – while the ellipse is still floating on the cursor, and before the center point of the ellipse is anchored – are: