Working with the Nets to Ignore Design Rule on a PCB in Altium Designer

Created: October 10, 2017 | Updated: September 26, 2019

Now reading version 20.2. For the latest, read: Placement - Nets to Ignore for version 21

Applies to Altium Designer versions: 18.0, 18.1, 19.0, 19.1, 20.0, 20.1 and 20.2

Rule category: Placement

Rule classification: Unary

Summary

This rule specifies which nets should be ignored.

All design rules are created and managed within the PCB Rules and Constraints Editor dialog. For a high-level view of working with the design rules system, see Defining, Scoping & Managing PCB Design Rules.

None, the rule applies to all nets targeted by the scope (Full Query).

Contentions are not possible.

Not currently observed by the DRC tool.

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?

You are reporting an issue with the following selected text
and/or image within the active document: