Altium NEXUS Documentation

Client_Cmd-ToggleProcessStatusBarToggleProcessStatusBar_AD

Created: July 27, 2015 | Updated: April 11, 2017
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: Client Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to toggle the display of the Command Status Bar on or off. The Command Status Bar provides information about the command currently being used.

Access

This command is accessed from any editor by choosing the View » Command Status command, from the main menus.

Use

After launching the command, the Command Status Bar will either disappear or reappear, depending on whether it is currently visible or not.

Tips

  1. When a command is not currently being used, this will be reflected in the bar through the status Idle state - ready for command.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: