Contact Us
Contact our corporate or local offices directly.
Parent page: PCB Panel
The Collaborate, Compare and Merge panel
The Collaborate, Compare and Merge panel is command-central for performing a copper comparison between two versions of the same PCB design. It requires that the board is currently under version control and that the repository that it is stored in is configured in the Data Management - Design Repositories page of the Preferences dialog. The panel checks if the board is the latest revision (known as the Head revision). If it is not, it indicates what must be done to bring it up to date.
The board is divided into cells in the Difference Map. When you click on a cell the differences in that cell are detailed in the lower section of the panel, and also in the main workspace. The Difference Map also includes Layer tabs, use these to examine the differences on each layer.
Head |
The latest revision committed to the version control system. |
Base |
The revision the local copy of the document was derived from, also known as the checked out revision. |
Working Copy |
Local copy of the version controlled document on which editing is performed. |
Local changes |
Changes made on the working copy that have not been committed to version control. |
Status : Up to Date |
The base revision is the head revision and no local changes have been made. |
Status : Out of Date |
The base revision is older than the Head revision and no changes have been made to the working copy. |
Status : Modified |
The base revision is the Head revision and changes have been made to the working copy. |
Status : Merge required |
The base revision is older than the Head revision and local changes have been made, i.e., the file is both modified and out of date. |
Resolve |
The act of updating the base revision number to the Head revision number. This will transform the status from merge required to modified. |
When you click on a command in this region of the panel to initiate a Comparison, the software compares your file against the latest revision in the repository and displays the differences in the Difference Map region of the panel, as well as in the main editing workspace.
The Actions section of the panel is used for the following:
Work in Progress regions are polygonal areas that each designer working on a board can place to show where they are currently working. These can then be displayed, hidden or removed.
The two Show work in progress commands display current regions in the Difference Map and main editor window. These can be hidden by clicking the red cross that appears when either command is run.
The Manually mark an area command presents you with an editing cursor in the main editing window. The placement behavior is the same as placing a solid polygonal region on your board: click to place each corner, press Shift+Spacebar to change the corner mode, Spacebar to change the corner start/end, and right-click to close the shape.
You can clear your own work in progress regions at any time using the Clear all My Work in Progress Regions command.
When the panel is opened, the software automatically checks the revision number of your board and compares it to the revision number of the Head revision. If they are not the same, the Version control status will indicate what needs to be done to make them the same.
When a comparison is performed, the board is divided into cells (the cell size is defined at the top of the panel in the Settings region). The Difference Map presents these cells in a checkerboard fashion. As you hover the cursor over a cell, its cell reference is displayed, such as G4. Click on a cell to display that cell in the main editing window.
Cells that contain differences are shaded in color, the choice of color reflecting ownership of those changes as defined in the color key just below the map of the board. Clicking on a colored cell details all the differences in the Differences section at the bottom of the panel.
The region at the bottom of the panel displays the Difference and Type of difference detected in the currently selected cell.
When working in Collaborative PCB Design, some objects/features are not supported by the merge process. Supported/not supported objects are detailed below.
Supported:
Not supported:
Contact our corporate or local offices directly.