Altium NEXUS Documentation

InfoMeasure

Created: June 11, 2016 | Updated: April 11, 2017
現在、バージョン 2.1 をご覧頂いています。 最新情報については、バージョン 4 の をご覧ください。

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to measure and display the distance between any two points in the current document.

Access

This command can be accessed from the CAMtastic Editor by:

  • Choosing the Analysis » Measure » Point to Point command from the main menus.
  • Clicking the  button on the CAMtastic Standard toolbar.
  • Using the Shift+M keyboard shortcut.

Use

First, ensure that the CAMtastic panel is visible.

After launching the command, the cursor will change to a small cross, and you will enter measurement mode. Measurement involves the following sequence of actions:

  1. Position the cursor at the location where you wish to start measuring from, and click.
  2. Move the cursor to the end point and click again - as you move, a guide line will stretch from the start point to help you.
  3. Measurement information will appear on the Info tab of the CAMtastic panel, reporting the point-to-point distance measured, the coordinates of the start and end points, the X and Y distances, and the angle created from the horizontal.
  4. Continue measuring the distance between other points, or press Esc to exit measurement mode.

Tips

  1. All measurement information uses the current units for the workspace - either inches or millimeters. Units can be changed either from the CAMtastic panel, or the CAM Editor - Drawing Modes page of the Preferences dialog.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: