ActiveBOM_Dlg-PcbSourceSelectionDialogChoose PCB to Use_AD

This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer and a connected Altium 365 Workspace. Check out the FAQs page for more information.

The Choose PCB to Use dialogThe Choose PCB to Use dialog

Summary

The Choose PCB to Use dialog is used to select which PCB parameters are to be made available in an ActiveBOM when a PCB project includes more than one PCB file.

Visit the ActiveBOM page to learn more.

Access

The dialog is accessed by clicking  in the Sources region on the Columns tab of the ActiveBOM Properties panel.

The dialog is accessed only if the PCB project includes more than one PCB document.

Options/Controls

  • PCB Files - this is a list of all PCB files detected in the current PCB project. Select the PCB to use then click OK. The following PCB-specific parameters will be extracted from that PCB and presented in the Columns list, ready to be included in ActiveBOM.
    • Center-X (Mil) - geometric center of the component
    • Center-Y (Mil)
    • Center-X (mm)
    • Center-Y (mm)
    • Layer
    • Pad-X (Mil) - location of Pad 1
    • Pad-Y (Mil)
    • Pad-X (mm)
    • Pad-Y (mm)
    • Ref-X (Mil) - location of component reference point (as defined in the PCB library editor)
    • Ref-Y (Mil)
    • Ref-X (mm)
    • Ref-Y (mm)
    • Rotation

 

If you find an issue, select the text/image and pressCtrl + Enterto send us your feedback.