Altium NEXUS Documentation

RemoveCoverlayRegion

Created: 14.01.2021 | Updated: 22.01.2021

Parent page: PCB Commands

The following pre-packaged resources, derived from this base command, are available:


Applied Parameters: None

Summary

This command is used to remove a coverlay region.

Access

The command is accessed from the PCB editor in Board Planning Mode by right-clicking over a Flex coverlay region then choosing Coverlay Actions » Remove Coverlay. The required coverlay layer must be the active layer in the main design space.

The current viewing mode for the PCB document can be changed using the corresponding commands from the main View menu. To switch to Board Planning Mode, use the command of the same name, or use the 1 keyboard shortcut.

Use

First, ensure that a coverlay region is present on the PCB. After launching the command, the coverlay region will be removed.

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: