Altium NEXUS Documentation

AbortSimulation

Created: 12.06.2016 | Updated: 11.04.2017

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to abort the current simulation analysis and waveform generation, in the SimData Editor's Waveform Analysis window.

Access

This command is accessed from the SimData Editor by clicking the  button on the SimView Standard toolbar.

Use

After launching the command, the simulation will be stopped. The waveforms for any collected data will be displayed to the extent that they are already generated, up to the point of the abort. In some cases, waveforms will be partially displayed, in other cases, no data will be present.

 

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: