Altium NEXUS Documentation

ClearFilter

Created: 12.06.2016 | Updated: 11.04.2017

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to clear the existing waveform filter that is currently being applied in the active analysis chart.

Access

This command can be accessed from the SimData Editor by:

  • Choosing the Wave » Clear Filter command from the main menus.
  • Using the Esc (or Shift+C) keyboard shortcut.

Use

After launching the command, the currently applied filter will be cleared and all waveforms will become fully visible again in the Waveform Analysis window. The previously selected waveform, on whose name the scope of the applied filter was based, will become deselected.

Tips

  1. The current filter can also be cleared by using the Clear button, located at the bottom-right of the Waveform Analysis window.

 

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: