Altium NEXUS Documentation

ModifyWaveColors

Created: 12.06.2016 | Updated: 11.04.2017

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to run the Modify Wave Colors dialog, from where you can change the color brightness of all waveforms in the currently active chart.

Access

This command is accessed from the SimData Editor by choosing the Tools » Brightness command from the main menus.

Use

After launching the command, the Modify Wave Colors dialog appears. The dialog essentially contains three buttons, allowing you to lighten the colors of all waveforms in the chart, darken the colors, or reassign the original color depths. Clicking the buttons will cause the waveform colors to change so that you can experiment with color depths. Actual change is not effected until clicking OK.

 

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: