Applied Parameters: None
This command is used to rotate selected objects in the workspace counterclockwise or clockwise and by a specified angle of rotation.
This command can be accessed from the PCB Editor and PCB Library Editor when configured in 2D Layout Mode by:
- Locating and using the Rotate Selection command on the Active Bar.
Ensure that only the objects you want to rotate are selected in the main design workspace.
After launching the command, the Rotation Angle (Degrees) dialog will open. Enter the required angle of rotation, from 0.001° to 360.00°. Enter a positive value for counterclockwise rotation or a negative value for clockwise rotation. Click OK to close the dialog then position the cursor and click to define the reference point for rotation. The selected objects will be rotated about the reference point by the entered angle.
- The Undo command can be used to restore the rotated selection.