Altium NEXUS Documentation


Created: July 7, 2017 | Updated: September 18, 2017
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: SystemDesigner Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to change the view in the main design window, such that the active Multi-board Schematic document (*.MbsDoc) is made completely visible (where possible).

For a high-level look at multi-board design within Altium NEXUS, see Designing Systems with Multiple Boards.


This command can be accessed from the Multi-board Schematic Editor by:

  • Choosing the View » Fit Document command, from the main menus.
  • Using the Ctrl+PgDn keyboard shortcut.


After launching the command, the view in the main design window will change in order to fit the entire document, where possible. This of course will depend on the current sizing of the main design workspace within Altium NEXUS, but the software will attempt to fit what it can, with the center of the document at the center of the main design window.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: