Altium NEXUS Documentation

SimView_Cmd-ClearFilterClearFilter_AD

Created: March 9, 2022 | Updated: March 9, 2022
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: SimView Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to clear the existing waveform filter that is currently applied in the active analysis chart.

Access

This command can be accessed from the SimData Editor in the following ways:

  • Choose the Wave » Clear Filter command from the main menus.
  • Use the Esc (or Shift+C) keyboard shortcut.

Use

After launching the command, the currently applied filter will be cleared and all waveforms will become fully visible again in the Waveform Analysis window. The previously selected waveform, on whose name the scope of the applied filter was based, will become deselected.

Tip

The current filter can also be cleared by using the Clear button located at the bottom-right of the Waveform Analysis window.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: