Altium NEXUS Documentation

EditVertexDelete

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to remove an existing vertex from a line, or polyline object, in the current document.

Access

This command is accessed from the CAMtastic Editor by choosing the Edit » Vertex » Delete command from the main menus.

Use

After launching the command, you will be prompted to select the vertex you wish to delete. Simply position the cursor over the vertex you wish to remove, and click. The vertex will be removed and the polyline will be redrawn accordingly.

Continue deleting further vertices, or right-click, or press Esc, to exit.

Tips

  1. A line, by definition, must have at least two vertices (i.e. its end points) and therefore you cannot delete a vertex from a line that has only two vertices.
  2. If you click on a segment of the polyline, the oldest-placed vertex for that segment will be the one deleted.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: