Altium NEXUS Documentation

ToolsNetListEx

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to extract the netlist from the Gerber information in the current document.

Access

This command is accessed from the CAMtastic Editor by choosing the Tools » Netlist » Extract command from the main menus.

Use

After launching the command, the netlist information will be extracted, and a list of nets will appear on the Nets tab of the CAMtastic panel.

Tips

  1. Each net is listed in terms of its total length. Clicking on any net entry in the panel will cause the net to be selected and zoomed in the main design workspace.
  2. The nets extracted are given arbitrary names. To assign meaningful net names, as defined in the PCB design, ensure that the relative IPC-D-356 formatted netlist is loaded, and use the Rename Nets command.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: