Altium NEXUS Documentation

PolylineLineMode

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to change from drawing arcs to drawing lines, while placing a polyline object in the current document.

Access

This command is accessed from the CAMtastic Editor, when placing a polyline, by right-clicking and choosing the Change to Line command from the context menu.

Use

After launching the command, the current mode for polyline placement will change to line, and a line segment will appear extending from the last vertex point placed.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: