Altium NEXUS Documentation

SelmenuEntity

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to select objects in the workspace, one at a time.

Access

This command can be accessed from the CAMtastic Editor by:

  • Choosing the Edit » Selection » Object command from the main menus.
  • Using the Alt+O keyboard shortcut.

Use

After launching the command, the cursor will change to a small square and you will enter single object selection mode. Simply position the cursor over an object to be selected, and click. Continue adding further objects to the selection as required.

Tips

  1. You must be in editing mode (carrying out an editing operation), before this command will become available.
  2. Objects will only be selected if the Add selection mode is enabled.
  3. Using this command on an existing selection, and with the Remove selection mode enabled, will cause clicked objects to become deselected.
  4. The objects added/removed will depend on the selection modes enabled - Flash/Point and/or Draws.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: