Altium NEXUS Documentation

InfoMeasureObject

Created: June 11, 2016 | Updated: April 11, 2017

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to measure and display the shortest distance between any two objects in the current document.

Access

This command is accessed from the CAMtastic Editor by choosing the Analysis » Measure » Object to Object command from the main menus.

Use

First, ensure that the CAMtastic panel is visible and that the netlist for the design is available (on the Nets tab of the panel). You may need to extract the netlist first.

After launching the command, the cursor will change to a small square, and you will enter measurement mode. Measurement involves the following sequence of actions:

  1. Position the cursor over the first object and click.
  2. Move the cursor over the required second object and click again. A visual connecting line will appear at the location where the distance between the two objects is the shortest.
  3. Measurement information will appear on the Info tab of the CAMtastic panel, reporting this shortest point-to-point distance, the coordinates of the start and end points of the connecting line, the X and Y distances, and the angle created from the horizontal.
  4. Continue measuring the distance between other objects, or press Esc to exit measurement mode.

Tips

  1. All measurement information uses the current units for the workspace - either inches or millimeters. Units can be changed either from the CAMtastic panel, or the CAM Editor - Drawing Modes page of the Preferences dialog.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: