Altium Designer Documentation

InsertLine

Created: June 27, 2017 | Updated: July 24, 2017

Parent page: PcbDrawing Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This command is used to place a Line object into the active Draftsman document (*.PCBDwf).

For a high-level look at how the Altium Draftsman Drawing System provides an interactive approach to the creation of production documentation for your PCBs, see Draftsman. For detailed information about this object type, see Line.

Access

This command can be accessed from the PcbDrawing Editor by:

  • Choosing the Place » Line command from the main menus.
  • Locating and using the Line command () on the Active Bar.
If the command has been recently used from the Active Bar, it will become the active/visible button. Where other commands are available, this is indicated by a triangle at the bottom-right corner of the button. Click and hold on the active button to access a menu of all associated commands for that grouping.
  • Clicking the  entry on the Graphical Tools drop-down () of the Drawing Annotations toolbar.
  • Right-clicking in the workspace and choosing the Place » Line command from the context menu.

Use

After launching the command, the cursor will change to a cross-hair and you will enter line placement mode. Placement is made by performing the following sequence of actions:

  1. Click to anchor the starting point of the line.
  2. Move the cursor to adjust the length of the line and click to anchor the end point (which can be placed at any angle with respect to the start point), thereby completing placement.
  3. Continue placing further lines, or right-click, or press Esc, to exit placement mode.

Tips

  1. Placement will observe snapping options for the document, if enabled. Snapping can be defined in the General section of the Properties panel (set to present the Document Options, when no objects are selected in the workspace).
  2. A line can be graphically modified after placement. Click on it to select it - editing handles will appear at its end points. Click and drag a handle to move the start or end point of the line, and therefore also change its length. Click on it - away from editing handles - and drag to move to a different location within the current sheet.
  3. Most aspects of a placed line are available for editing through the Properties panel. If the panel is already open, simply select a placed line to populate the panel with its associated properties. If the panel is not open, double-click on the line to access it.
  4. Defaults for this primitive type can be defined on the Draftsman - Defaults page of the Preferences dialog.

 

Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

お問合せ

お近くの営業所にお問合せください。

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: