Altium NEXUS Documentation


Created: June 11, 2016 | Updated: April 11, 2017
Applies to Altium NEXUS Client versions: 1.0, 1.1, 2.0, 2.1, 3.0, 3.1, 3.2, 4 and 5
This documentation page references Altium NEXUS/NEXUS Client (part of the deployed NEXUS solution), which has been discontinued. All your PCB design, data management and collaboration needs can now be delivered by Altium Designer (with Altium Designer Enterprise Subscription) and a connected Altium 365 Workspace. Check out the FAQs page for more information.

Parent page: CAMtastic Commands

The following pre-packaged resource, derived from this base command, is available:

Applied Parameters: None


This command is used to rename the nets that have been extracted from the Gerber information in the current document, with the names that appear in the imported IPC-D-356 formatted netlist file.


This command is accessed from the CAMtastic Editor by choosing the Tools » Netlist » Rename Nets command from the main menus.


First ensure that the netlist for the current CAM document has been extracted, and that you have imported the IPC-D-356 netlist.

After launching the command, the nets will be compared and those that were extracted from the current document will be renamed using the net names from the IPC netlist file. The updated names will appear on the Nets tab of the CAMtastic panel.


Found an issue with this document? Highlight the area, then use Ctrl+Enter to report it.

Contact Us

Contact our corporate or local offices directly.

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
You are reporting an issue with the following selected text
and/or image within the active document: