Altium Designer Documentation

Undo

Created: 08.08.2017 | Updated: 08.08.2017

Parent page: UnifiedComponent Commands

The following pre-packaged resource, derived from this base command, is available:


Applied Parameters: None

Summary

This feature is used to restore the current document to its state previous to the last operation. Multiple levels of undo are supported.

Access

This command can be accessed from the Component Library Editor, when configured in Batch Editor mode, by:

  • Clicking the  button on the Component Library Standard toolbar.
  • Using the Ctrl+Z keyboard shortcut.
The command only becomes available provided a change to the document has been made.
If the Component Library Editor is currently in Single Component Editor mode, switch to the Batch Editor mode using the Tools » Switch to Batch Editor command.

Use

After launching the command, the last operation will be 'undone' and the document will be returned to its previous state.

Tips

  1. A command that has been 'undone' using this command, can be 'redone' using the Redo command.

 

Обнаружили проблему в этом документе? Выделите область и нажмите Ctrl+Enter, чтобы оповестить нас.

Связаться с нами

Связаться с нашими Представительствами напрямую

We're sorry to hear the article wasn't helpful to you.
Could you take a moment to tell us why?
200 characters remaining
Вы сообщаете о проблеме, связанной со следующим выделенным текстом
и/или изображением в активном документе: